TIG Welding of EN AW-6082 Al Alloy: A Comparative Analysis of Filler Rods on Microstructural and Mechanical Performance

Abstract

This study investigates the impact of different filler wires (ER5356, ER4043, and ER4047) on the microstructural and mechanical properties of EN AW-6082 Al alloy joints produced by tungsten inert gas (TIG) welding. Butt-welded samples with a single V-groove joint configuration were prepared using optimized welding parameters. The welded samples were subjected to visual inspection, microstructural analysis, hardness testing, tensile testing, and impact toughness evaluation. The results showed that all the welds were free of visible defects. Microstructural examination revealed that the ER5356 filler produced the finest grain structure of 18.03 ± 3 μm, while ER4047 resulted in the coarsest grains of 36.07 ± 5 μm. Correspondingly, the joints made with ER5356 exhibited the highest tensile stress of 278 ± 6 MPa, yield stress of 219 ± 5.4 MPa, hardness values of 72.7 ± 5 HV, and welding efficiency of 86.07%, whereas those made with ER4047 produced the lowest values. The hardness in the weld region was lower than that in the parent metal and heat-affected zone for all samples. However, ER4047 welds demonstrated superior impact toughness and strain-hardening capacity. The findings underscore the importance of filler metal selection in tailoring mechanical properties for high-performance applications.