MARATTO

article · Molecules

Sustainable Conversion of Corncob Biomass Waste into High Performance Carbon Materials for Detection of VOCs at Room Temperature

Abstract

The demand for reliable, cost-effective, room temperature gas sensors with high sensitivity, selectivity, and short response times is rising, particularly for environmental monitoring, biomedicine, and agriculture. In this study, corncob waste-derived activated carbon (ACC) was combined with CuO nanoparticles and polyvinyl alcohol (PVA) to fabricate ACC/PVA/CuO composites with CuO loadings of 5, 10, and 15 wt.%. The CuO nanoparticles (average size: 21.79 ± 9.88 nm) were successfully incorporated into the ACC matrix, as confirmed by TEM, XRD, and N<sub>2</sub> adsorption-desorption analyses. Increasing CuO content reduced the specific surface area due to pore blockage but enhanced the composites' ethanol sensing performance. The ACC/PVA/CuO (15 wt.%) sensor exhibited the highest response and fastest recovery times (125 s and 130 s, respectively, at 100 ppm ethanol), outperforming other composites and pristine ACC. This improvement was attributed to surface defects and increased active sites promoting vapor adsorption and diffusion. These results demonstrate the potential of ACC/PVA/CuO as an effective ethanol sensor at room temperature.

Research topics

  • Gas Sensing Nanomaterials and Sensors
  • Analytical Chemistry and Sensors
  • Advanced Chemical Sensor Technologies

Sustainable Development Goals

Read the original research

This page summarises published work. The authoritative version sits with the publisher.

DOI: 10.3390/molecules30010110

Is something wrong with this record? Report it or request removal.

Discussion

Discuss this research

Have you built on this work, tried to replicate it, or seen it applied in practice? Share what you know. Verified researchers and MARATTO™ domain experts can open a discussion, and any member can reply. Contributions are reviewed before they appear.

No discussion yet. Open the first thread.